Singular Feeding Of Cut Sheet Media - KIP Color 80 Operator's Manual

2. 4. 2

Singular feeding of cut sheet media

A large cut sheet media can not be fed by multi-feeding.
Please feed it singularly as instructed in below.
"Large sizes" are as follows.
Metric : A1 landscape (210mm x 297mm)
A0 portrait (1189mm x 841mm)
841mm wide (Not standard length)
NOTE
Do not leave the cut sheet media for a long time on the Bypass Feeder as it will get moisture,
which will result in a mis-feed or image defect. (Put the media in a vinyl bad to block the
moisture.)
1. Select the cut sheet feeding mode on the output device connected to the KIP Color 80.
Refer to your system reference for media source information.
2. Sliding left and right, place the cut sheet guides
properly according to the size of cut sheet media.
3. Put the media on the Bypass Feeder, and move it in the direction of arrow until contacted to
the feeding roller.
The feeding rollers rotate automatically to place the cut sheet media at the starting position.
Feeding roller
4. Output a copy/print job from the output device.
Inch : 30" wide (Not standard length)
34" wide (Not standard length)
36" wide (Not standard length)
Cut sheet guides
1-28