KIP Color 80 Operator's Manual page 120

3. Looking into the machine through the open hole on
the inside plate, check if the mis-fed is held
between the rollers in the Fuser region.
Whether or not it is held between the rollers
decides what to do next.
•
If the media is held between the rollers as the
following left photo, proceed to the next
procedure 3.
•
If the media is not held as the following right
photo, please follow the instruction in
[3.2.8 Mis-feed around the Transportation Unit
1 Region (Code: J-0121, J-0221 & J-0421)]
Media
Media is held between rollers.
4. Open the Transportation Unit 1 to 4 orderly from the top to the bottom until the leading edge of
the mis-fed media is found.
NOTE
Make sure to open the Transportation Units before removing the mis-fed media. Otherwise the
inside of machine will become dirty with the toner.
Roller
Transportation Unit 1
Transportation Unit 2
Transportation Unit 3
Transportation Unit 4
1-115
Open hole
Roller
Roller
Media is not held between rollers.