KIP Color 80 Operator's Manual page 116

2. Check if the mis-fed is cut or not by pulling it.
Whether the media is cut or not decides what to do
next.
•
If the mis-fed media is cut and can be removed
from the machine easily, proceed to the
following procedure 3.
•
If it has not been cut yet so can not be
removed from the machine, jump to the
procedure 4. (Procedure 3 is not needed.)
NOTE
Large green cylinder called "Photoconductive Drum" is inside of each Transportation Unit. It is
the most important part to get a good print image, so no dirt or no damage must be given to it.
•
Touching onto its surface will provide a fingerprint. Do not touch the surface of Drum
when removing the mis-fed media.
•
Contacting a hard material thing onto its surface will result in a scratch mark. Take off
the watch, the ring and some other hard material thing before removing the mis-fed
media.
3. After removing the mis-fed media from the Bottom Corner region, check if some more media is
found around there. Whether or not the media is found decides what to do next.
•
If the media is found as the following left photo, proceed to the next procedure 4 to cut the
roll media.
•
If it is not found, no more operation is required. Just close the Transportation Unit 4.
The concerned roll deck automatically rewinds the leading edge to the print start position.
Media
Media is found
4. Open the Right Side Door.
Media is not found
Right Side Door
1-111