Portcfgexport Options - HP A7533A - Brocade 4Gb SAN Switch Base Administrator's Manual

switch:admin> portcfgexport 7/10 -a 1 -f 30
switch:admin> portcfgexport 7/10
Port 7/10
Admin:
State:
Pid format:
Operate mode:
Edge Fabric ID:
Preferred Domain ID:
Front WWN:
Fabric Parameters:
R_A_TOV:
E_D_TOV:
Authentication Type: None
DH Group: N/A
Hash Algorithm: N/A
Edge fabric's primary wwn: N/A
Edge fabric's version stamp: N/A

portCfgExport options

This port can now connect to another switch. The following list describes the options for the
portCfgExport command. For more information about the portCfgExport and portCfgVexport
commands, see the Fabric OS Command Reference Manual.
-a
-f
-r
-e
-d
-p
-t
-m
236 Using the FC-FC routing service
info
enabled
NOT OK
Not Applicable
Brocade Native
30
160
50:06:06:9e:20:38:6e:1e
Auto Negotiate
Not Applicable
Not Applicable
Sets the EX_Port to enabled (1) or disabled (2). Admin use only.
Sets the fabric ID (1 to 128). Each edge fabric must have a unique ID, and
EX_Ports (or VEX_Ports) connected to the same edge fabric must have the same
fabric ID. The default value is the port number divided by 3, plus 2 and rounded
down.
Sets the R_A_TOV used for port negotiation (2000 - 120000).
Sets the E_D_TOV used for port negotiation (1000 - 60000).
Preferred front domain ID (1-239). This command enforces the use of the same
preferred front domain ID for all the ports connected to the same edge fabric.
When this option is specified, the preferred front domain ID is compared against
the online ports. If the preferred front domain ID is different, an error message is
issued and the command fails.
When the -d option is not specified, if there are online ports connected to the
same edge fabric, the preferred front domain ID is set to the preferred front
domain ID of those online ports. Otherwise, if there are offline ports that are set
to EX_Port, the preferred front domain ID is set to those offline ports. If none of the
above conditions apply, the existing value is left untouched.
Sets the PID format (0-native, 1-core, 2-extended-edge). The value must match the
edge fabric setting. The default value is 1.
Sets the negotiate fabric parameters (1-enable, 2-disable)
Sets the port mode. (0-Brocade, 1-Open, 2-McDATA Fabric, 3-McDATA Fabric
Legacy). This command enforces the use of the same port mode for all the ports
connected to the same edge fabric.
When this option is specified, the port mode is compared against the online
ports. If the modes are different, an error message is issued and the command
fails.
When the -m option is not specified:
If there are online ports connected to the same edge fabric, the mode is set to the
mode of those online ports. Otherwise, if there are offline ports that are set to
EX_Port, the mode is set to those offline ports.
If none of the above conditions apply, the existing value is left untouched.