xStack® DGS-3120 Series Managed Switch Web UI Reference Guide
Parameter
Target IP Address
Repeat Pinging for
Size (EI Mode Only)
Timeout
Click the Start button to initiate the Ping Test.
After clicking the Start button, the following page will appear:
Click the Stop button to halt the Ping Test.
Click the Resume button to resume the Ping Test.
Trace Route
The trace route page allows the user to trace a route between the switch and a given host on the network.
To view this window, click Monitoring > Trace Route as shown below:
Description
Enter an IP address to be pinged.
Enter the number of times desired to attempt to Ping either the IPv4 address or the
IPv6 address configured in this window. Users may enter a number of times between
1 and 255.
For IPv6 only, enter a value between 1 and 6000. The default is 100.
Select a timeout period between 1 and 99 seconds for this Ping message to reach its
destination. If the packet fails to find the IP address in this specified time, the Ping
packet will be dropped.
Figure 11–25 Ping Test Result window
Figure 11–26 Trace Route window (SI Mode Only)
300