D-Link DGS-3120-24TC Product Manual page 120

xStack® DGS-3120 Series Managed Switch Web UI Reference Guide
Click the Apply button to accept the changes made for each individual section.
Click the Add button to add a new entry based on the information entered.
Click the Edit button to configure the MLD Snooping Multicast VLAN Settings for the specific entry.
Click the Delete button to remove the specific entry.
Click the Profile List link to configure the MLD Snooping Multicast VLAN Settings for the specific entry.
After clicking the Edit button, the following page will appear:
The fields that can be configured are described below:
Parameter
VLAN Name
State
Replace Source IP
Remap Priority
Replace Priority
Untagged Member
Ports
Tagged Member Ports
Untagged Source Ports
Tagged Source Ports
based on the remap priority. This flag will only take effect when the remap priority is
set.
Figure 4–73 MLD Snooping Multicast VLAN Settings – Edit window
Description
This option will display the VLAN name of the VLAN configured.
Use the drop-down menu to enable or disable the state.
With the MLD snooping function, the MLD report packet sent by the host will be
forwarded to the source port. Before forwarding of the packet, the source IP
address in the join packet needs to be replaced by this IP address. If none is
specified, the source IP address will not be replaced.
0-7 – The remap priority value (0 to 7) to be associated with the data traffic to be
forwarded on the multicast VLAN.
None – If None is specified, the packet's original priority is used. The default setting
is None.
Tick the check box to specify that the packet's priority will be changed by the
switch, based on the remap priority. This flag will only take effect when the remap
priority is set.
Specify the untagged member port of the multicast VLAN. Click the Select All
button to select all the ports or click the Clear All button to unselect all the ports.
Specify the tagged member port of the multicast VLAN. Click the Select All button
to select all the ports or click the Clear All button to unselect all the ports.
Specify the source port or range of source ports as untagged members of the
multicast VLAN. The PVID of the untagged source port is automatically changed to
the multicast VLAN. Source ports must be either tagged or untagged for any single
multicast VLAN, i.e. both types cannot be members of the same multicast VLAN
Specify the source port or range of source ports as tagged members of the
112