Figure 80: Portal Minimum Image Quality Configuration - Dell Precision R5400 User Manual

TERA1x00 PC-over-IP Administrative Interface User Manual
TER0606004 Issue 3
default setting of 90 can reduce the amount of bandwidth required per user while
maintaining a minimum limit on the user experience.
Note: This example uses the Administration Web Interface for configuring the Portal
for Minimum Image Quality and Maximum Initial Image Quality. The Portal OSD
may also be used to configure the Portal. See Section 2 On Screen Display (OSD)
for matching OSD functionality. The Maximum Initial Image Quality does not have
a corresponding parameter on the Portal OSD, as it is intended as an administrator
only parameter due to the impact on network traffic.
1. Open the Portal Administration Web Interface for the first user's Portal by using
an internet browser to open the Portal IP address
2. Log in to the Portal Administration Web Interface
3. Select the Image webpage from the Configuration menu

Figure 80: Portal Minimum Image Quality Configuration

4. Slide the Minimum Image Quality slider to the left
5. Slide the Maximum Initial Image Quality slider to the right
6. Select the Apply button to accept the changes
7. Repeat for the other three user Portals
The Minimum Image Quality is now configured towards Perception-Free to
increase the maximum quality the system will reduce to under any condition. This
effect will only be noticed in limited bandwidth cases. The Minimum Image Quality
feature does not alter the bandwidth usage.
© 2008 Teradici Corporation Page 99 of 111