TERA1x00 PC-over-IP Administrative Interface User Manual
TER0606004 Issue 3
Note: The Maximum Initial Image Quality does not have a corresponding
parameter on the Portal OSD, as it is intended as an administrator only parameter.
1.5.10 Monitor Emulation
The Monitor Emulation webpage allows an enabling and disabling the monitor
emulation feature.
This option is only available on a Host; on the Portal it is disabled and non-editable.
Figure 15: Monitor Emulation Configuration Webpage
1.5.10.1 Enable Monitor Emulation
When Enable Monitor Emulation is disabled, the Host will only respond to Display
Data Channel (DDC) when in a PC-over-IP session. When Enable Monitor
Emulation is enabled, the Host will use emulated data for DDC queries regardless if
in a PC-over-IP session of not.
There are Enable Monitor Emulation fields for both monitor ports available, DVI 1
and DVI 2.
1.5.11 Time
The Time webpage allows configuration of the Network Time Protocol (NTP) settings
to allow the event logs (see Section 1.7.1 Event Log) of the Portal and Host to be
time-stamped based on NTP time.
© 2008 Teradici Corporation
Page 33 of 111