Figure 36: Osd Logo Upload Webpage - Dell Precision R5400 User Manual

TERA1x00 PC-over-IP Administrative Interface User Manual

Figure 36: OSD Logo Upload Webpage

1.9.2.1 OSD logo filename
The OSD logo filename field specifies the filename of the logo image to be
uploaded. The administrator can browse to the file via the Browse button. The file
must be accessible to the web browser (i.e., on a local or accessible network drive).
The 24 bits per pixel image must be either JPG or BMP format, and dimensions
cannot exceed 256 pixels in width, 64 pixels in height. If the file extension is
incorrect, the web interface will display an error message.
1.9.2.2 Upload
Selecting the Upload button will cause the specified file to be transferred to the
device. The web interface will prompt the administrator for confirmation to avoid
accidental image uploads.
Example OSD Logo Upload Process:
1. Select the webpage Browse button to browse to the logo file
2. Select the File Upload window Open button
3. Select the webpage Upload button
4. Select the OK button on the 'Are you sure? This will upload a new logo for local
GUI. This operation may take a few minutes' warning window.
5. Wait for the OSD Logo upload to complete. The following message appears
when complete, "Success Flash successfully programmed! You must reset the
device for the changes to take effect."
6. Reset the Portal
© 2008 Teradici Corporation
TER0606004 Issue 3
Page 56 of 111