Bandwidth; Figure 45: Bandwidth - Dell Precision R5400 User Manual

TERA1x00 PC-over-IP Administrative Interface User Manual
Peer FQDN
2.3.4.3 Enable Auto-Reconnect
The Enable Auto-Reconnect option allows the Portal to automatically reconnect
with the last connected Host after a power-cycle.
2.3.4.4 Session Timeout
The Session Timeout configures the timeout for a connection. If the timeout period
elapses without the PC-over-IP processor detecting a network, the PC-over-IP
processor will disconnect the session.
2.3.5

Bandwidth

The Bandwidth tab allows limiting the Portal bandwidth.
Note: The Bandwidth can also be configured using the Webpage Administration
Interface. See Section 1.5.5 Bandwidth.

Figure 45: Bandwidth

2.3.5.1 Device Bandwidth Limit
The Device Bandwidth Limit parameter defines the maximum bandwidth for the
PC-over-IP system. The Bandwidth setting on the Portal side defines the bandwidth
from the Portal to Host (e.g. USB data).
Although the maximum bandwidth may be configured, the PC-over-IP system will
continue to use only the bandwidth required up to the Device Bandwidth maximum.
Peer MAC Address
Peer FQDN
© 2008 Teradici Corporation
TER0606004 Issue 3
PC-over-IP
Used with Portal RDP client only
Page 66 of 111