Using Scsiselect With Scsi Devices - Compaq Deskpro ap230 Hardware Reference Manual

Using SCSISelect with SCSI Devices

For additional information about installing optional SCSI devices,
refer to the documentation that comes with the device or contact your
Compaq authorized dealer, reseller, or service provider.
The Wide Ultra2 SCSI host adapter includes the SCSISelect utility to
configure the host adapter and to run SCSI disk utilities. To run the
SCSISelect utility:
In Post Messages Enabled mode: Press Ctrl+A when the Press


<Ctrl><A> for SCSISelect Utility message appears during POST.
In Post Messages Disabled mode: When the Compaq logo screen


appears, press any key to exit the logo screen. Immediately after
exiting the logo screen, press Ctrl+A to access the SCSISelect
utility.
A menu appears with the following options:
Configure/View Host Adapter Settings


SCSI Bus Interface Definitions
 
–
Host Adapter SCSI ID
–
SCSI Parity Checking
–
Host Adapter SCSI Termination
Additional Options
 
–
Boot Device Options
–
SCSI Device Configuration
–
Advanced Configuration Options
SCSI Disk Utilities




Lists all SCSI devices and SCSI ID numbers

For information about configuring POST message display
status, refer to Appendix B, "Computer Setup Utilities."
Hardware Reference Guide C-5