Using Scsiselect With Scsi Devices - Compaq Evo W8000 Hardware Reference Manual

Using SCSISelect with SCSI Devices

Compaq Evo Workstation W8000 Hardware Reference Guide
The SCSI host adapter includes the SCSISelect utility to configure
the host adapter and to run SCSI disk utilities. To run the SCSISelect
utility:
In POST Messages Enabled mode: Press
Press <Ctrl><A> for SCSISelect Utility message displays during
POST.
In POST Messages Disabled mode: When the Compaq logo
screen displays, press any key to exit the logo screen.
Immediately after exiting the logo screen, press
the SCSISelect utility.
A menu displays with the following options:
Configure/View Host Adapter Settings
SCSI Bus Interface Definitions
Host Adapter SCSI ID
SCSI Parity Checking
Host Adapter SCSI Termination
Additional Options
Boot Device Options
SCSI Device Configuration
Advanced Configuration Options
SCSI Disk Utilities
Lists all SCSI devices and SCSI ID numbers
For additional information about configuring POST message
display status, refer to the Computer Setup Guide on the Reference
Library CD.
Hard Drive Installation
when the
Ctrl + A
to access
Ctrl + A
B-7