Eaton 9130 User Manual page 22

5. Communication
RS 232 and USB Communication Ports
To establish communication between the UPS and a computer, connect your computer to one of
the UPS communication ports using an appropriate communication cable. See Figure 21 for the
communication port locations.
When the communication cable is installed, power management software can exchange data with the
UPS. The software polls the UPS for detailed information on the status of the power environment. If a
power emergency occurs, the software initiates the saving of all data and an orderly shutdown of the
equipment.
The cable pins for the RS 232 communication port are identified in figure 22, and the pin functions are
described in Table 8.
5 4 3
9 8
Figure 22. RS 232 Communication Port (DB-9 Connector).
Table 8. RS 232 Communication Port Pin Assignment
Pin Number
1
2
3
4
5
6
7
8
9
(1) Configurable; see the "Relay Configuration" setting in "User Settings" on page 15.
(2) If Pin 3 receives a Low (+V) signal for ≥ 5 seconds, the UPS executes the command selected by the "Signal Inputs" setting in "User
Settings" on page 15.
(3) When the selected condition is active, output signals on Pins 1 and 8 shift from Low (positive voltage) to High (negative voltage). When
the condition no longer exists, the output signal returns to Low.
Connectivity Cards
Connectivity cards allow the UPS to communicate in a variety of networking environments and with
different types of devices. The Eaton 9130 has one available communication bay for the following
connectivity cards:
Connect UPS-MS Web/SNMP Card - has SNMP and HTTP capabilities as well as monitoring
through a Web browser interface; connects to Ethernet network. In addition, a Environmental
Monitoring Probe can be attached to obtain humidity, temperature, smoke alarm, and security
information.
Relay Interface Card - has isolated dry contact (Form-C) relay outputs for UPS status: Utility
failure, Low battery, UPS alarm/OK, or On bypass.
See figure 21 on page 21 for the location of the communication bay.
ConnectUPS-MS Web/SNMP Card
Figure 23. Optional Connectivity Cards.
Remote Power-off
RPO is used to shut down the UPS from a distance. This feature can be used for shutting down the
load and the UPS by thermal relay, for instance in the event of room over temperature. When RPO is
activated, the UPS shuts down the output and all its power converters immediately. The UPS remains
on to alarm the fault.
Page 22
2 1
7 6
Signal Name Function
DCD Battery Low signal
RxD Transmit to external device
TxD Receive from external device
DTR PnP from external device (tied to Pin 6)
GND Signal common (tied to chassis)
DSR To external device (tied to Pin 4)
RTS No connection
CTS On Battery signal
RI +8-12 Vdc power
ETHERNET
100M
(1)(3)
(2)
(1)(3)
Setting/Sensor
Relay Interface Card
10M UPS data Reset
Direction from the UPS
Out
Out
In
In
—
Out
In
Out
Out
9130 UPS-EN