Dell SmartStep 200N Replacement Manual page 62

62 Floppy Drive
CAUTION: Before performing these procedures, shut down the
computer, disconnect it from the electrical outlet, and disconnect
the modem from the telephone wall jack.
NOTICE: Disconnect any attached devices from electrical outlets, and remove
any installed battery.
NOTICE: To avoid ESD, ground yourself by using a wrist grounding strap or
by touching an unpainted metal surface on the computer.
NOTICE: Read
"Preparing to Work Inside the
the following procedure.
Remove the palm rest.
1
1
1 floppy drive
2 M2 x 5-mm screw (1)
3 floppy drive cable
4 floppy drive connector
Remove the floppy drive cable from the floppy drive connector.
2
Remove the M2 x 5-mm screw that secures the floppy drive to the
3
system board, and lift out the drive.
Computer" before performing
2
3
4