Dell SmartStep 200N Replacement Manual page 47

1 large screw bumpers (2)
2 2.5 x 6 mm screws (5)
3 display bezel
4 display latch
Use a plastic scribe to pry the two large screw bumpers, the two small
3
screw bumpers, and the one screw cover out of the screw holes located
on the front of the bezel.
Remove the five M2.5 x 6-screws located on the front of the bezel.
4
NOTICE: Carefully separate the bezel from the top cover to avoid damage to
the bezel.
Starting at the bottom of the display panel, use your fingers to separate
5
the bezel from the top cover by lifting the inside of the bezel while
pushing in on the outside.
1
5
M2.5 x 6-mm inverter
screw
6
top cover
7
screw cover (1)
8
small screw bumpers (2)
2
3
Display Assembly and Display Latch
47