Dell SmartStep 200N Replacement Manual page 72

72 Speakers
1 speaker connector
2 battery bay
3 module bay
4 silver M2 x 4-mm screw
5 right speaker
Place the speakers in their slots on each side of the bottom case and
1
attach the speaker cable from the left speaker to the system board.
Replace the single, silver M2 x 4-mm screw that secures each speaker
2
to the bottom case.
Route the speaker cable under or between the cable routing clips, and
3
replace the tape so that the cable lies completely flat.
6
cable routing clips (7)
7
tape
8
speaker cable
9
left speaker
10 silver M2 x 4-mm screw
(1)