Gps Simulator - Eagle FISHSTRIKE 1000C Installation And Operation Instructions Manual

A Page display can show a limited number of data boxes. You can not
turn them off or add more data boxes.

GPS Simulator

The GPS simulator lets you use the unit as if you were outdoors
navigating somewhere. It's a great way to practice using your unit. You
can set the starting location by entering latitude/longitude (Starting
Position) or from a stored waypoint, map place or POI location (
C
HOOSE
command). You can steer your position and change speed on the
S
TART
map by using the arrow keys ( command) or by setting
S A
TEER WITH RROWS
the track and speed in the dialog boxes provided on the simulator menu
screen.
To get to the GPS Simulator:
1. Press | |↓ to | .
MENU MENU GPS S ENT
ETUP
2. Press ↓ to
| . The GPS Simulator Menu appears.
GPS S ENT
IMULATOR
GPS Setup Menu (left); GPS Simulator menu (right).
Choose the desired settings, then turn the simulator on by highlighting
the box and pressing key. Press | |
GPS S O ENT EXIT EXIT EXIT
IMULATOR N
to close this menu. A message and tone appear periodically, warning
you that the simulator is on. To turn the simulator off, repeat the above
steps or turn the unit off.
While in simulator mode, you can press to clear the steering and
EXIT
speed boxes from the screen while continuing the simulation. This will
allow you to use the map cursor during a simulation. To turn steering
and speed boxes back on again, return to the GPS Simulator menu,
select the command, press . Press to return
S A ENT EXIT
TEER WITH RROWS
to the previous page.
Simulating Trail or Route Navigation
In Simulator mode, your unit can automatically follow a trail or route
without manual steering if you use these steps:
142