Visual Trailing; Navigate A Trail (Forward) - Eagle FISHSTRIKE 1000C Installation And Operation Instructions Manual

The other two methods provide a full range of navigation data and work
with both the Map Page and Navigation Page. The only difference
between them is "navigating a trail" follows a trail forward (from start
to end) while "backtracking" follows a trail in reverse (from end to
start.)
When hiking at walking speed with a hand-held GPS, we often use
visual back trailing because it is a bit better at following each little
turn on a footpath. At faster speeds, such as the highway or on the
water, the Navigate Trail and Backtrack Trail commands are handy.

Visual Trailing

1. On the Map Page, zoom (
2. Begin moving and watch the Map Page. Simply walk or steer so your
current position arrow traces along the trail you have just made.
Tip:
Generally, when using this method, the smaller the zoom range, the
more accurately you will be able to steer along the trail.

Navigate a Trail (forward)

The following figures illustrate the menu sequence for navigating a
trail.
1. Press
MENU
2. Press ↓ to enter the Saved Trail list, then use ↑ or ↓ to select the
desired Trail Name|
3. Press → to
4. Press ↓ to
information along the trail.
NOTE:
If you are already located at or near the beginning of your trail, the
arrival alarm will go off as soon as you hit Enter. Just press
clear the alarm and proceed.
5. Now, begin moving and follow your unit.
6. When you reach your destination, be sure to cancel your navigation:
press |
MENU MENU
←
sure, press |
| |↓ to
MENU M
.
ENT
|↓ to
D T
ELETE RAIL
|
N ENT
AVIGATE
↓
| to
C
ANCEL
.
ENT
) so your flashing trail is visible.
ZIN or ZOUT
| .
T ENT
Y RAILS
|
N ENT
AVIGATE
. The unit begins showing navigation
N
AVIGATION
117
.
| . The unit asks if you're
ENT
to
EXIT