Eagle FISHSTRIKE 1000C Installation And Operation Instructions Manual page 123

Sequence for saving a trail and beginning a new one. My Trails
command (left). The Trails Menu (center). The arrow to the right of
Trail 17 indicates the trail is "active," and the check to the left
indicates the trail is visible on the map display. The third figure (right)
shows the Edit Trail menu, with the Active command selected.
↓
2. Press to the active Trail Name|
→
3. Press , then
4. To return to the previous page, press
left the Edit Trail menu, you will notice a new trail was started with a
new sequential number. In the example below, the new trail is number
15, showing zero points. Note Trail 14 is inactive, but is still visible on
the map.
A new trail, Trail 15, is created when Trail 14 is made inactive. Any
new travel will be recorded in this trail, which is active and visible.
Trails do not need to be visible in order to be active.
You can save and recall up to 10 different plot trails, which can be
copied to your MMC for archiving or for transfer to your MapCreate
software.
Visible
symbol
↓
to |
A ENT
CTIVE
Active
symbol
.
ENT
. This unchecks the Active option.
EXIT
115
| | |
EXIT EXIT EXIT
. As you