Basic Sonar Quick Reference - Eagle FishElite 320 Installation And Operation Instructions Manual

Eagle electronics installation and operation instructions fish-finding sonars & mapping gps fishelite 320, seacharter 320df

Table of Contents

1. Mount the transducer, antenna and unit. Connect the unit to electric

power and the transducer. (If GPS operation is desired, connect GPS

antenna, too.) Make sure the MMC is in. (See complete installation de-

tails beginning on page 13.)

2. Launch your boat.

3. To turn on the unit, press and release

4. Opening screen displays Map Page. Rotate through the four main

Page screens (Map Page, Satellite Status Page, Navigation Page, Sonar

Page) by pressing

Pages to display Sonar Page.

5. If GPS data is desired, wait while unit locates satellites and calculates

current position. When the unit acquires position, a tone sounds and a posi-

tion acquired message appears.

6. With position acquired (if desired), head for your fishing grounds.

Your unit will automatically display digital depth and surface water

temperature in the top left corner of the screen.

The auto settings will track the bottom, displaying it in the lower por-

tion of the screen. The full sonar chart will scroll from right to left,

showing you what's under the boat as you cruise across the water. You

can change the display by:

Zoom in to enlarge the chart for more detail: press

Zoom out to return to full chart mode: press

7. Watch the display for the appearance of fish arches. When you see

arches, you've found fish! Stop the boat and get your lure or bait into

the water at the depth indicated on the sonar chart.

8. Gauge the fish depth by visually comparing the fish arches with the

depth scale on the right side of the screen, or get a more accurate

measure with the Depth Cursor. Press

Press ↓ to align the cursor line with the fish arch. The exact depth ap-

pears in a box at the right end of the cursor line. To clear the cursor,

press

EXIT

9. If you are drifting at a very low speed or anchored, you are not mov-

ing fast enough for a fish to return the tell-tale fish arch signal. As you

drift over a fish, or as a fish swims through the transducer's signal

cone, the fish echo will appear as a straight line suspended between the

surface and the bottom.

10. To turn off the unit, press and hold