Grayline - Eagle FishElite 320 Installation And Operation Instructions Manual

To change the frequency setting to 50 kHz:
1. From the Sonar Page, press
2. Press ↓ to
50
3. Press |
EXIT
To change the frequency setting to 200 kHz:
1. From the Sonar Page, press
2. Press |
EXIT


Grayline

Grayline lets you distinguish between strong and weak echoes. It
"paints" gray on targets that are stronger than a preset value. This al-
lows you to tell the difference between a hard and soft bottom. For ex-
ample, a soft, muddy or weedy bottom returns a weaker signal which is
shown with a narrow or no gray line. A hard bottom returns a strong
signal which causes a wide gray line.
If you have two signals of equal size, one with gray and the other with-
out, then the target with gray is the stronger signal. This helps distin-
guish weeds from trees on the bottom, or fish from structure.
Grayline is adjustable. Experiment with your unit to find the Grayline
setting that's best for you.
At left, Sonar Page menu with Grayline command selected.
To adjust the Grayline level:
1. From the Sonar Page, press
2. The Grayline Control Bar appears. Press ↓ to decrease Grayline;
press ↑ to increase Grayline.
3. When it's set at the desired level, press
| .
H ENT
K Z
to clear the menu.
EXIT
to clear the menu.
EXIT
At right, the Grayline control bar.
|↓ to
MENU S
ONAR
|↓ to
MENU S
ONAR
|↓ to
MENU G
RAYLINE
EXIT
67
|
F ENT
EATURES
|
F ENT
EATURES
| .
ENT
.
.
| .
ENT