Gps Antenna/Receiver Module - Eagle FishElite 320 Installation And Operation Instructions Manual

If the base of the transom has a radius, fill the gap between the tran-
som and the sensor with the caulking compound. This will help ensure
a smooth water flow.
Route the sensor's cable through or over the transom to the sonar unit.
If you need to drill a hole in the transom to pass the connector through,
the required hole size will depend on the connector on the end of your
sensor's cable. If the sensor has a manual locking collar connector, you
will need to drill a 7/8" hole. If it has a push-on self-sealing connector,
you will need to drill a 5/8" hole.
Manual locking collar connector
requires a 7/8" hole.
Caution:
If you drill a hole in the transom for the cable, make sure it is lo-
cated above the waterline. After installation, be sure to seal the
hole with the same marine grade above- or below-waterline seal-
ant used for the screws.
The sensor is now ready for use. Connect the sensor to the in-line con-
nector on the MY-4X adapter cable or to the accessory plug on the back
of the unit. If you have any questions concerning the installation of the
sensor, please contact your local boat dealer.

GPS Antenna/Receiver Module

This unit's package includes the EGC-12w GPS module. This device con-
tains the unit's external antenna and receiver for GPS and WAAS signals.
The antenna/receiver module comes with a 25-foot extension cable. This
module can be mounted on a flat surface or pole, or a magnet is available
for temporary mounting on any ferrous surface (call customer service).
EGC-12w Module, bottom view (left) and top view (right).
Push-on self-sealing connector
requires a 5/8" hole.
30