Dynex DX-E401 User Manual page 15

Configuring the router
Field
MAC Address The default MAC address is set to the WAN's physical interface MAC address on
the broadband router. We do not recommend that you change the default MAC
address unless required by your ISP.
Clone MAC Address The default MAC address is set to the WAN's physical interface MAC address on
the broadband router. You can click Clone MAC Address to copy the MAC
address of your Ethernet card, or you may be required to enter the MAC address of
your router. We recommend that you do not change the default MAC address
unless required by your ISP.
Primary/Secondary Use this if you do not want to use the one provided by your ISP.
DNS Address
MTU Use only if required by your ISP. Otherwise, leave the default setting.
C
ONFIGURING A STATIC
Set a static IP address if all WAN IP information is provided to you by your ISP. You
will need to enter in the IP address, subnet mask, gateway address, and DNS
address(es) provided to you by your ISP. Each IP address entered in the fields must
be in the appropriate IP form, which are four numbers (up to three digits each)
separated by a dot (x.x.x.x). The router will not accept the IP address if it is not in
this format.
To configure a static IP address:
1 Open the Configuration menu by following the instructions in To access the
Web-based configuration utility: on page 13.
Description
IP
ADDRESS
15