Cannot Adjust Printhead; Cannot Calibrate; Excessive Temperature Or Humidity - Canon imagePROGRAF iPF6000S User Manual

Cannot adjust printhead.

The Printhead nozzles are clogged.
Highly transparent lm is loaded that cannot be used
for Printhead adjustment.

Cannot calibrate.

The paper for printing a test pattern for adjustment is
soiled. Otherwise, colored paper is loaded.
The printed test pattern is faint.
Direct sunlight or strong lighting may be shining on
the printer and causing the sensor to malfunction.

Excessive temperature or humidity.

The temperature or humidity where the printer is
installed is out of the acceptable range for printer
operation.
Cause
Cause
Cause
Messages regarding printing or adjusment
Corrective Action
Follow the steps below to check the nozzles.
1.
Print a test pattern to check the nozzles.
(→P.624)
2.
Clean the Printhead if the nozzles are clogged.
(→P.625)
We recommend using a type of paper that you often
use, other than lm, for Printhead adjustment.
(→P.571)
Corrective Action
Load unused paper compatible with color calibration.
(→P.104)
Take steps to remedy the faint printing.
(→P.664)
Take steps to ensure the printer is not used when
exposed to direct sunlight or strong lighting.
Corrective Action
Press the Stop button and stop printing.
Use the printer in an environment that meets the
requirements for the operating environment. Note
that various environmental conditions are also
recommended for various types of paper. For details
on the recommended environmental conditions for
paper, see "Paper Reference Guide."
(→P.104)
Press the OK button and complete color calibration.
However, calibration may not be completed
successfully.
Error Message 697