The Surface Of The Paper Is Dirty; The Back Side Of The Paper Is Dirty - Canon imagePROGRAF iPF6000S User Manual

The surface of the paper is dirty

The Paper Retainer is soiled.
You are using a paper that does not dry easily.

The back side of the paper is dirty

The Platen has become dirty after borderless printing
or printing on small paper.
The Paper Retainer is soiled.
Roller marks are left across the trailing edge of paper
A document was removed after printing from
the Front Paper Feed Slot without pressing the
Load/Eject button.
Immediately After Borderless Printing, the Trailing Edge
Margin is Soiled During Regular Printing
Depending on your printing environment, after
borderless printing in which the leading and trailing
edge of the roll is cut automatically, any ink adhering
to the cutter unit may rub off on the next printed
document.
Cause
Cause
Cause
Cause
Problems with the printing quality
Corrective Action
Clean the Paper Retainer.
(→P.644)
Specify a time of about a minute in Roll DryingTime.
Corrective Action
Open the Top Cover and clean the Platen.
(→P.641)
Clean the Paper Retainer.
(→P.644)
Corrective Action
Following the instructions, press the Load/Eject
button, remove the paper, and then press the OK
button.
Wipe away any soiling on the rollers.
(→P.641)
(→P.644)
Corrective Action
Follow these steps to set the Between Pages setting
of Drying Time in a range of 30 seconds to 3 minutes
before borderless printing.
1.
On the Main sheet of the printer driver, click
Settings in Media Type.
2.
Select the ink drying time in the Between Pages
list of Drying Time.
Troubleshooting 667