Messages regarding printing or adjusment
Messages regarding printing or adjusment
Use another paper.
The Printhead and feed amount cannot be adjusted
when highly transparent lm is loaded.
Cannot execute this command. Use other paper.
The loaded paper cannot be used for color calibration. Load paper compatible with color calibration. (*1)
*1: Always make sure the loaded paper matches the media type setting on the printer. Adjustment cannot
be completed correctly unless the setting value matches the loaded paper.
Cannot print as specied.
Press Load/Eject and replace paper with A4/LTR (vertical) or larger
Paper has been loaded that is too small to
print the test pattern for printhead adjustment
or nozzle checking.
Press Load/Eject and replace roll with 10 in. wide or larger roll.
Paper has been loaded that is too small to
print the test pattern for printhead adjustment
or nozzle checking.
Cannot adjust band.
The Printhead nozzles are clogged.
Highly transparent lm is loaded that cannot be used
for automatic feed amount adjustment.
Paper is loaded that cannot be used for Standard
Adj. in Auto Band Adj..
696 Error Message
Cause
Cause
Cause
Cause
Cause
For automatic Printhead adjustment, we recommend
using a type of paper that you often use, other than
lm.
(→P.571)
Adjust the feed amount manually.
(→P.580)
See "Paper Reference Guide."
(→P.104)
Corrective Action
Press the Load/Eject button and switch to paper A4/Letter,
vertical, or larger.
Corrective Action
Press the Load/Eject button and load a roll at least 10
inches (254 mm) wide.
Follow these steps below to check the nozzles.
1.
Print a test pattern to check the nozzles.
(→P.624)
2.
Clean the Printhead if the nozzles are clogged.
(→P.625)
Adjust the feed amount manually.
(→P.580)
Execute Auto Band Adj. > Advanced Adj..
(→P.578)
Corrective Action
Corrective Action
Corrective Action