HP 316095-B21 - StorageWorks Edge Switch 2/24 Release Note page 6

Important information
This section describes important information related to the HAFM software, the Edge
Switch 2/24, Edge Switch 2/32, Director 2/64, Director 2/140, and McDATA 4Gb
SAN Switch.
Features not supported in this release
The following HAFM features are not supported in this release:
• SANtegrity Security Center
• Group Configuration Manager
These features are described in the documentation released with HAFM 08.08.00 and
firmware 08.01.00. Some of these features may be available in a future release.
Adding McDATA 4Gb SAN Switch to HAFM management
A McDATA 4Gb SAN Switch is added to HAFM management the same way as other
M-Series switches, with one additional configuration requirement. The username and
password for the Administrator account of the switch must be configured in HAFM. The
default username and password for a McDATA 4Gb SAN Switch are preconfigured for
the switch in HAFM when the switch is added to HAFM management. If the switch
username and password have not been changed from the default settings, no change is
required. The default user name is admin, and the default password is password.
To configure the username and password though HAFM:
1.
Select Discover > Setup.
The Discover Setup dialog box is displayed.
2.
Click Add.
The Address Properties dialog box is displayed.
3.
Enter the description, IP address, and subnet mask in the appropriate boxes.
4.
Select the Product Type and Access tab.
The Address Properties dialog box with Product Type and
Access tab is displayed.
5.
Enter the switch user ID and password for the Administrator account.
6.
Click OK.
Disabling the SNMP Proxy
SNMP Proxy is enabled by default on all McDATA 4Gb SAN Switches. To ensure proper
functionality of HAFM, the SNMP Proxy feature must be disabled prior to discovering
the McDATA 4Gb SAN Switch in HAFM.
4