HP 316095-B21 - StorageWorks Edge Switch 2/24 Release Note page 21

the down time but it is actually unknown. The reporting is inaccurate for that portion
of the graph.
FL Ports do not show destination icon or destination port in performance graphs
FL Ports do not show destination switch icon or destination port in performance graphs.
This is because there can be up to 127 devices on a loop port, and they cannot be
displayed in the space in the tables.
Removing a Port Fencing Threshold Policy may not occur as expected under
specific conditions
Under specific conditions, a Port Fencing Threshold Policy may remain active even if the
user has removed it. This occurs when you are in the same Port Fencing configuration
session:
1. A particular Port Fencing Threshold Policy is not currently applied to any switch.
2. The same Port Fencing Threshold Policy is applied to switch port(s).
3. The same Port Fencing Threshold Policy is selected in the ISL Threshold table (left
panel), and Remove is clicked in order to remove this policy.
4. The Port Fencing configuration session is completed (by clicking OK).
Under these conditions, the Port Fencing Threshold Policy is not successfully removed and
is active on the switch ports where the policy was applied.
Workaround
This can be corrected by repeating the selection of the Port Fencing Threshold Policy
in the ISL Threshold table (left panel), by clicking Remove, and then clicking OK. The
Port Fencing Threshold Policy will then be removed correctly. This can be avoided by
also selecting the Port Fencing Threshold Policy on the switch ports where it was applied
(right panel), and removing the policy from the switch port(s), before completing the
session (step 4 above).
User-defined nicknames for node devices do not show in Connection Properties
If you select Show Route between two node devices with user-defined Nicknames, the
Nicknames for these nodes do not display in the Connection Properties when you
double-click the route.
Port WWN is listed in the Node WWN field of Properties dialog box of a
node device
When you right click on a node device in the Product List, and select Properties from the
popup menu, the Properties dialog displays the Port WWN in the Node WWN field
HA-Fabric Manager release notes
19