Top Cover Removal - Lexmark 2390 003 - B/W Dot-matrix Printer Service Manual

Top Cover Removal

1. Turn the printer off.
2. Disconnect the power cord at the printer.
3. 23XX-001 - Remove the paper advance knob [1] by pulling to
the right.
4. If the tractor assembly is installed in the pull tractor position,
remove the tractor assembly see
page 4-50.
5. Remove the front cover [2] and the ribbon access cover [3].
6. Release the two latches [9], and then remove the rear cover [3].
7. Set the paper select lever [4] to the cut sheet position.
8. Remove the two screws [8].
9. Stand the printer on its side. Insert a flat blade screwdriver into
each of the five holes in the bottom cover and release the five
latches that secure the top cover [5] to the bottom cover [6].
"Pull Tractor Removal" on
Repair Information 4-61