Lower Pinch Roller Removal
Note: The lower pinch roller and the pinch roller gear must be
ordered separately.
1. Remove the top cover
see
"Top Cover Removal" on page
2. Remove the center pinch roller ground spring.
3. Remove the left and right pinch roller springs [1].
4. Move the carrier to the right as far as it will go.
5. Slide the left end of the lower pinch roller to the front of the
printer and lift it up and to the left to remove it.
6. Be sure to perform the Printhead-to-Platen Gap Adjustment
procedure see
4-2.
4-32
"Printhead-to-Platen Gap Adjustment" on page
4-61.