Roller, lower pinch removal
1.
Remove the rear cover. See
2.
Remove the top cover. Go to
3.
Slide the carrier to the far left of the printer.
4.
Remove the four screws (A) from the paper feed motor bracket.
5.
Remove the screw from the top of the serial interface card bracket.
6.
Disconnect the paper feed motor cable from the logic board, and then remove the paper feed motor and
bracket from the printer.
7.
Slide the carrier to the left side of the printer.
"Covers, rear removal" on page
"Covers, top removal" on page
B
B
2580+, 2581+, 2590+, 2591+
4-5.
4-5.
Repair information
Previous
Next
Go Back
4-31