Installing A Concurrent Kvm Card - IBM HS12 - BladeCenter - 8028 Service Manual

1. Before you begin, read "Safety" on page v and "Installation guidelines" on
page 31.
2. If the blade server is installed in a BladeCenter unit, remove it (see "Removing
the blade server from the BladeCenter unit" on page 33).
3. Remove the blade server cover (see "Removing the blade server cover" on page
35 for instructions).
4. If an optional expansion unit is installed, remove it (see "Removing an optional
expansion unit" on page 37).
5. If an I/O expansion card or a high-speed expansion card is installed, remove it
(see "Removing an I/O expansion card" on page 50 or "Removing a
high-speed expansion card" on page 55).
6. Gently pivot the narrow end of the card out of the cKVM card connectors;
then, slide the notched end of the card out of the tabs on the expansion card
bracket and lift the card out of the blade server.
7. If you are instructed to return the cKVM card, follow all packaging
instructions, and use any packaging materials for shipping that are supplied to
you.

Installing a concurrent KVM card

To install a cKVM card, complete the following steps.
Note:
1. The following illustration shows how to install the cKVM in the system board.
2. The illustrations in this document might differ slightly from your hardware.
cKVM card
Chapter 5. Removing and replacing blade server components
49