IBM HS12 - BladeCenter - 8028 Service Manual page 116

v Follow the suggested actions in the order in which they are listed in the Action column until the problem is
solved.
v See Chapter 4, "Parts listing, Types 8014, 8028 and 1916," on page 25 to determine which components are CRUs
and which components are FRUs.
v If an action step is preceded by "(Trained service technician only)," that step must be performed only by a
trained service technician.
Error code Description
00150100 Multi-bit error occurred: forcing NMI
DIMM=xx DIMM=yy (could not isolate)
00150200 SERR: Addr or Spec. Cyc. DPE Slot=xx
Vendor ID=xxxx Device ID=xxxx
Status=xxxx
104
BladeCenter HS12 Type 8014, 8028 or 1916: Problem Determination and Service Guide
Action
1. Reseat following components one at a time, in
the order shown, restarting the blade server each
time:
a. DIMMs xx and yy - .
b. Optional expansion unit (if one is installed) -
See "Removing an optional expansion unit"
on page 37 and "Installing an optional
expansion unit" on page 38.
2. Replace the following components, one at a time,
in the order shown, restarting the blade server
each time:
a. DIMMs xx and yy -
b. Optional expansion unit (if one is installed) -
See "Removing an optional expansion unit"
on page 37 and "Installing an optional
expansion unit" on page 38.
c. (Trained service technician only) System-board
assembly - See "Removing the system-board
assembly" on page 65 and "Installing the
system-board assembly" on page 66.
1. If an optional expansion unit is installed, reseat it
- See "Removing an optional expansion unit" on
page 37 and "Installing an optional expansion
unit" on page 38.
2. Reseat the I/O expansion card in slot xx; then,
restart the blade server.
3. Replace the following components, one at a time,
in the order shown, restarting the blade server
each time:
a. I/O expansion card in slot xx -
b. Optional expansion unit (if one is installed) -
See "Removing an optional expansion unit"
on page 37 and "Installing an optional
expansion unit" on page 38.
c. (Trained service technician only) System-board
assembly - See "Removing the system-board
assembly" on page 65 and "Installing the
system-board assembly" on page 66.