Installing A Concurrent Kvm Feature Card - IBM 8853L6U Service Manual

6. Gently pivot the narrow end of the card out of the cKVM card connectors; then,
7. If you are instructed to return the Concurrent KVM Feature Card, follow all

Installing a Concurrent KVM Feature Card

To install a Concurrent KVM (cKVM) Feature Card, complete the following steps.
1. Touch the static-protective package that contains the expansion card to any
2. Locate the concurrent-KVM connector and orient the Concurrent KVM Feature
3. Slide the right side of the card (the side of the card that is away from the
4. Install the Memory and I/O Expansion Blade, if one was removed from the blade
5. If you removed a small-form-factor expansion card or a high-speed expansion
6. Install the blade server cover (see "Installing the blade server cover" on page
7. Install the blade server into the BladeCenter unit (see "Installing the blade
slide the notched end of the card out of the tabs on the expansion card bracket
and lift the card out of the blade server.
packaging instructions, and use any packaging materials for shipping that are
supplied to you.
unpainted metal surface on the BladeCenter unit or any unpainted metal surface
on any other grounded rack component; then, remove the Concurrent KVM
Feature Card from the package.
Card.
concurrent-KVM connector) between the two tabs at the right side of the
expansion card bracket; then, gently pivot the card into the connector.
Note: For device-driver and configuration information to complete the
installation of the Concurrent KVM Feature Card, see the documentation that
comes with the card.
server when the concurrent KVM card was removed (see "Installing an
expansion unit" on page 27).
card, reinstall it (see "Installing a small-form-factor expansion card" on page 37
or "Installing a high-speed expansion card" on page 40).
25).
server in a BladeCenter unit" on page 22).
cKVM feature card
Chapter 4. Removing and replacing blade server components
35