Table of Contents
Advertisement
The storage interface card comes in the SAS and SATA controller models. The SAS
storage interface card controls the SAS storage drives and the SATA storage
interface card controls the SATA and solid state storage drives.
Note:
1. The following illustration shows how to remove a storage interface card from
2. The illustrations in this document might differ slightly from your hardware.
Storage
interface
card standoff
To remove a storage interface card, complete the following steps.
1. Before you begin, read "Safety" on page v and "Installation guidelines" on
2. If the blade server is installed in a BladeCenter unit, remove it (see "Removing
3. Remove the blade server cover (see "Removing the blade server cover" on page
4. If an optional expansion unit is installed, remove the expansion unit (see
5. Gently lift the card out of the expansion-card connectors; then, slide the
6. If you are instructed to return the storage interface card, follow all packaging
Installing a storage interface card
Use this information to install a storage interface card in the blade server.
The storage interface card comes in SAS and SATA controller models. The SAS
storage interface card controls the SAS storage drives and the SATA storage
interface card controls the SATA and solid state storage drives.
Note:
1. The following illustration shows how to install a storage interface card in the
2. The illustrations in this document might differ slightly from your hardware.
54
BladeCenter HS12 Type 8014, 8028 or 1916: Problem Determination and Service Guide
the system board.
Storage interface
card
page 31.
the blade server from the BladeCenter unit" on page 33 for instructions).
35 for instructions).
"Removing an optional expansion unit" on page 37).
notched end of the card out of the raised hook on the storage-interface card
standoff and lift the card out of the blade server.
instructions, and use any packaging materials for shipping that are supplied to
you.
system board.
Advertisement
Table of Contents
