How To Configure Wep - NETGEAR WG102 - ProSafe Wireless Access Point Reference Manual

Reference Manual for the NETGEAR ProSafe 802.11g Wireless Access Point WG102
Log in to the WG102 using its default address of
1.
address the unit is currently configured. Use the default user name of admin and default
password of password, or whatever password you set up.
Click the Wireless Settings link in the main menu of the WG102.
2.
The default SSID is NETGEAR-0.
3.
Note: The SSID of any wireless access adapters must match the SSID you configure in the
NETGEAR WG102 ProSafe 802.11g Wireless Access Point. If they do not match, you will
not get a wireless connection to the WG102.
As appropriate, select the Country/Region in which the wireless interface will operate.
4.
For now, do not make other changes
5.
Click Apply to save your changes.
6.
Note: If you are configuring the WG102 from a wireless computer and you change the
SSID, channel, or security settings, you will lose your wireless connection when you
click Apply. You must then change the wireless settings of your computer to match the
new settings.
Configure and test your PCs for wireless connectivity.
7.
Program the wireless adapter of your PCs to have the same SSID and channel that you
configured in the WG102. Check that they have a wireless link and are able to obtain an IP
address by DHCP from the WG102.
Once your PCs have basic wireless connectivity to the WG102, you can configure the advanced
wireless security functions.

How to Configure WEP

To configure WEP data encryption, follow these steps:
Log in to the WG102 using its default address of
1.
address the unit is currently configured Use the default user name of admin and default
password of password, or whatever LAN address and password you have set up.
3-20
http://192.168.0.229
http://192.168.0.229
Basic Installation and Configuration
November 2005
or at whatever IP
or at whatever IP