NETGEAR WG102 - ProSafe Wireless Access Point Reference Manual page 63

Reference Manual for the NETGEAR ProSafe 802.11g Wireless Access Point WG102
Table 4-1. General Information Fields
Field
Access Point Information
Access Point Name
(NetBIOS name)
Country/Region
Firmware Version
Access Point Mode
VLAN (802.1Q)
Management VLAN ID
Current IP Settings
IP Address
Subnet Mask
Default Gateway
DHCP Client
MAC Address
Current Wireless Settings
Channel/Frequency
Security Profiles
Management
Description
The default name may be changed if desired.
Displays the domain or region for which the wireless access point is
licensed for use. It may not be legal to operate this wireless access
point in a region other than one of those identified in this field.
The version of the firmware currently installed.
Identifies the operating mode of the WG102: Access Point,
Point-to-point bridge, Multi-point bridge or Repeater.
Indicates if VLAN support is enabled. The default is diabled.
Displays the VLAN ID.
The IP address of the wireless access point.
The subnet mask for the wireless access point.
The default gateway for the wireless access point communication.
Enabled indicates that the current IP address was obtained from a
DHCP server on your network. Disabled indicates a static IP
configuration.
Displays the Media Access Control address (MAC address) of the
wireless access point's Ethernet port.
Identifies the channel the wireless port is using. 11 is the default
channel setting. See
http://documentation.netgear.com/reference/enu/wireless/index.htm
for the frequencies used on each channel.
For each Security Profile, the following are displayed: Profile name,
SSID, security option, VLAN ID, and enabled/disabled.
November 2005
4-3