NETGEAR WG102 - ProSafe Wireless Access Point Reference Manual page 102

Reference Manual for the NETGEAR ProSafe 802.11g Wireless Access Point WG102
• Session
• Presentation
• Application
The IEEE 802.11 Standard encompasses the physical layer (PHY) and the lower portion of the data link
layer. The lower portion of the data link layer is often referred to as the Medium Access Controller (MAC)
sublayer.
MAC (Media Access Control)
Every wireless 802.11 device has its own specific MAC address hard-coded into it. This unique identifier
can be used to provide security for wireless networks. When a network uses a MAC table, only the 802.11
radios that have had their MAC addresses added to that network's MAC table will be able to get onto the
network.
Mesh Networks
Also called mesh topology, mesh is a network topology in which devices are connected with many
redundant interconnections between network nodes. In a full mesh topology every node has a connection to
every other node in the network. Mesh networks may be wired or wireless.
In a wireless mesh example, each of the spheres below represent a mesh router. Corporate servers and
printers may be shared by attaching to each mesh router. For wireless access to the mesh, an access point
must be attached to any one of the mesh routers.
Multiple Input Multiple Output (MIMO)
MIMO refers to radio links with multiple antennas at the transmitter and the receiver side to improve the
performance of the wireless link.
NAT (Network Address Translation)
A network capability that enables a houseful of computers to dynamically share a single incoming IP
address from a dial-up, cable or xDSL connection. NAT takes the single incoming IP address and creates
new IP address for each client computer on the network.
8
November 2005
Glossary