Hardware Description; Front Panel - NETGEAR WG102 - ProSafe Wireless Access Point Reference Manual

Reference Manual for the NETGEAR ProSafe 802.11g Wireless Access Point WG102

Hardware Description

The NETGEAR WG102 ProSafe 802.11g Wireless Access Point front and rear hardware functions
are described below.

Front Panel

Figure 2-1: WG102 front panel
Viewed from left to right, the WG102 has these four status LEDs: PWR, TEST, LAN, and WLAN.
LED DESCRIPTION
Power Indicator
PWR
Off No power. If this LED does not come on with the power adapter and cord correctly
installed, see Chapter 4, Troubleshooting.
On Power is on.
Self Test Indicator
TEST
Blink Indicates self test, loading software, or system fault (if continues).
Note: This LED may blink for a minute before going off.
Ethernet link indicator
LAN
Off No connection detected on the Ethernet link
Amber On Indicates 10 Mbps Ethernet link detected
Amber Flashing Data is being transmitted or received on the 10 Mbps Ethernet link
Green On 100 Mbps Fast Ethernet link detected.
Green Flashing Data is being transmitted or received on the 100 Mbps Ethernet link
Wireless LAN Link Activity Indicator
WLAN
Off Indicates no wireless link activity.
Green Blink Wireless link activity.
2-6
November 2005
Introduction