Cisco WRP400-G1 - Wireless Router Administration Manual page 159

WRP400 Provisioning Reference
Feature/XML
Tag
LAN DHCP
<LAN_DHCP>
Switch Rate
<SWITCH_RATE>
Cisco Small Business WRP400 Administration Guide
Parameters
<LAN_DHCP>dhcp_lease,dhcp_defa
ult_lease</LAN_DHCP>
dhcp_lease: Client lease time in
minutes; numerals from 1 to 9999
dhcp_default_lease: Default lease
time in minutes; numerals from 1 to
9999
NOTE: Dhcp_default_lease allows
the Service Provider to configure the
length of the "default lease time." By
default, the client lease time is set to
"0," meaning 1 day.
<SWITCH_RATE>mv_switch_total_rate_li
mit,mv_switch_ingress_mcast_rate</
SWITCH_RATE>
mv_switch_total_rate_limit: Limits the
switch throughput; numerals from 1 to
200 (default is 4)
mv_switch_ingress_mcast_rate: Ingress
multicast rate in Mbps; numerals from 1 to
100 (default is 80)
NOTE: The switch rate is set by
dividing 200 by the
mv_swtich_total_rate_limit. With the
default value of 4, the throughput is
limited to 50Mbps.
MPORTANT: It is highly recommended to
keep the default switch rate settings.
Default settings hae been tested to
support the appropriate Quality of
Service for the IPTV video transmission
towards the et-top box, in addition to
maintaining the appropriate Quality of
Service of the Voice Telephony
transmission.
Examples
To set the client lease time: <LAN_DHCP>
dhcp_default_lease=888 </LAN_DHCP>
To set lease time and default lease time:
<LAN_DHCP>dhcp_lease=777,dhcp_
default_lease=888</LAN_DHCP>
To set the switch rate limit to 40 Mbps and the
multicast rate to 40 Mbps:
<SWITCH_RATE>mv_switch_total_rate_
limit=5,mv_switch_ingress_mcast_rate=40</
SWITCH_RATE>
C
157