Cisco WRP400-G1 - Wireless Router Administration Manual page 115

Advanced Voice Fields
User page
Cisco Small Business WRP400 Administration Guide
Voice tab > User page >
Supplementary Service Settings section
The WRP400 provides native support of a large set of enhanced or
supplementary services. All of these services are optional. The parameters listed
in the following table are used to enable or disable a specific supplementary
service. A supplementary service should be disabled if a) the user has not
subscribed for it, or b) the Service Provider intends to support similar service
using other means than relying on the WRP400.
CW Setting
Block CID Setting
Block ANC Setting
DND Setting
CID Setting
CWCID Setting
Dist Ring Setting
Secure Call Setting If yes, all outbound calls are secure calls by default.
Message Waiting
Call Waiting on/off for all calls.
The default is yes.
Block Caller ID on/off for all calls.
The default is no.
Block Anonymous Calls on or off.
The default is no.
DND on or off.
The default is no.
Caller ID Generation on or off.
The default is yes.
Call Waiting Caller ID Generation on or off.
The default is yes.
Distinctive Ring on or off.
The default is yes.
The default is no.
This value is updated when there is voice mail notification
received by the WRP400. The user can also manually
modify it to clear or set the flag. Setting this value to yes
can activate stutter tone and VMWI signal. This parameter
is stored in long term memory and will survive after reboot
or power cycle.
The default is no.
A
113