Notes To The Electrician - Hayward Super Pump Owner's Manual

Super pump series
Table of Contents

Advertisement

Super Pump
Series _____ _____
WARNING
from lawn mowers, hedge trimmers and other equipment.
WARNING
required and test procedures for GFCI, see manufacturer's instructions. Pump MUST be permanently connected to GFCI.
WARNING
death. To reduce the risk of electric shock, the electrician must comply with installation instructions and must bond the pump
accordingly. In addition, the licensed electrician must also conform to local electrical codes for bonding requirements.

Notes to the electrician

Use a solid copper conductor, size 8 or larger. Run a continuous wire from external bonding lug to reinforcing rod or mesh. Connect
2
a No. 8 AWG (8.4 mm
) solid copper bonding wire to the pressure wire connector provided on the motor housing and to all metal
parts of swimming pool, spa, or hot tub, and to all electrical equipment, metal piping (except gas piping), and conduit within 5 ft. (1.5
m) of inside walls of swimming pool, spa, or hot tub. IMPORTANT - Reference NEC codes for all wiring standards including, but
not limited to, grounding, bonding and other general wiring procedures. NOTE - The National Electrical Code (NEC) permits use of
a cord with a maximum 3 ft. (1 m) length. If your pump is equipped with a cord complying with the NEC, the preceding four (4)
hazards apply.
Body Suction Entrapment- A pressure applied to a large portion of the body or limbs can result in an entrapment.
Evisceration/ Disembowelment- A negative pressure applied directly to the intestines through an unprotected suction outlet
sump or suction outlet cover which is damaged, broken, cracked, missing, or unsecured can result in
evisceration/disembowelment.
Mechanical Entrapment- There is potential for jewelry, swimsuits, hair decorations, fingers, toes, or knuckles to be caught
in an opening of a suction outlet cover resulting in mechanical entrapment.
- Dual suction fittings shall not be located on seating areas or on the backrest for such seating areas.
- The maximum system flow rate shall not exceed the values shown in the "Pipe Sizing Chart" found at the bottom of page 5
of this manual.
- Never use pool or spa if any suction outlet component is damaged, broken, cracked, missing, or not securely attached.
- Replace damaged, broken, cracked, missing, or not securely attached suction outlet components immediately.
- In addition to two or more suction outlets per pump installed in accordance with latest IAF (formerly NSPI) standards and
CPSC guidelines, follow all national, state, and local codes applicable.
- Installation of a vacuum release or vent system, which relieves entrapping suction, is recommended.
WWW.HAYWARDPOOL.COM
_____
WARNING
Electric Shock. Hazardous voltage can shock, burn, cause death or serious property damage. To reduce
the risk of electric shock, do NOT use an extension cord to connect unit to electric supply. Provide a
properly located outlet. All electrical wiring MUST be in conformance with applicable local and
national codes and regulations. Before working on pump or motor, turn off power supply to the pump.
To reduce the risk of electric shock replace damaged wiring immediately. Locate conduit to prevent abuse
A licensed electrician must install a Ground Fault Circuit Interrupter (GFCI) in circuit. For size of GFCI
Failure to bond pump to pool structure will increase risk for electrocution and could result in injury or
:
WARNING
Suction in suction outlets and/or suction outlet covers, which are damaged, broken, cracked, missing, or
unsecured cause severe injury and/or death due to the following entrapment hazards:
Hair Entrapment- Hair can become entangled in suction outlet cover.
Limb Entrapment- A limb inserted into an opening of a suction outlet sump or suction outlet cover that
is damaged, broken, cracked, missing, or not securely attached can result in a mechanical bind or
swelling of the limb.
WARNING
- When outlets are small enough to be blocked by a person, a minimum of two functioning suction
outlets per pump must be installed. Suction outlets in the same plane (i.e. floor or wall), must be
installed a minimum of three feet (3') [0.91 meter] apart, as measured from near point to near
point.
- Dual suction fittings shall be placed in such locations and distances to avoid "dual blockage" by
a user.
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
_____
It is required that licensed electricians do all electrical wiring. Risk of
Suction Entrapment Hazard.
-
To Reduce the risk of Entrapment Hazards:
_____________________Page 3 of 15

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents