Hayward SP2805X7 Owner's Manual

Hayward SP2805X7 Owner's Manual

Max-flo pump series

Advertisement

P/N: IS2800X5
Rev. C
__________________________________________________________________________________________
OWNER'S MANUAL
INSTALLATION, OPERATION, & PARTS
Max-Flo
P
Series
UMP
The Hayward Max-Flo™ is specifically engineered for the demanding requirements of today's in-ground swimming pool/spa that is
equipped with large capacity filters, heaters, and pool cleaning equipment. The Max-Flo™ is a self-priming pump that incorporates
an improved seal and impeller design that will provide many years of efficient, dependable, corrosion-free service. The advanced
design provides superior performance while reducing maintenance requirements.
Hayward Pool Products
620 Division Street, Elizabeth, NJ 07207
Phone: (908) 351.5400
www.haywardnet.com

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SP2805X7 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Hayward SP2805X7

  • Page 1 Max-Flo Series The Hayward Max-Flo™ is specifically engineered for the demanding requirements of today’s in-ground swimming pool/spa that is equipped with large capacity filters, heaters, and pool cleaning equipment. The Max-Flo™ is a self-priming pump that incorporates an improved seal and impeller design that will provide many years of efficient, dependable, corrosion-free service. The advanced design provides superior performance while reducing maintenance requirements.
  • Page 2: Important Safety Instructions

    Components such as the filtration system, pumps, and heaters must be positioned to prevent children from using them as a means of access to the pool. USE ONLY HAYWARD GENUINE REPLACEMENT PARTS Page 2 of 16 Max-Flo™ PUMP Series...
  • Page 3 A storable pool is constructed so that it is capable of being readily disassembled for storage and reassembled to its original integrity. SAVE THESE INSTRUCTIONS USE ONLY HAYWARD GENUINE REPLACEMENT PARTS Page 3 of 16 Max-Flo™ PUMP Series...
  • Page 4: General Information

    General Information Introduction ™ This manual contains information for the proper installation and operation of the Hayward Max-Flo Series. The instructions in this manual MUST be followed precisely. Failure to install according to defined instructions will void warranty. Product Benefits ...
  • Page 5: Pipe Sizing Chart

    Ground Fault Circuit Interrupter (GFCI) tripping indicates electrical problem. If GFCI trips and won’t reset, consult electrician to inspect and repair electrical system. WARNING – Fire Hazard. Match supply voltage to motor nameplate voltage. USE ONLY HAYWARD GENUINE REPLACEMENT PARTS Page 5 of 16 Max-Flo™ PUMP Series IS2800X5 Rev. C...
  • Page 6 Pump MUST be permanently connected to GFCI. In case of a power outage, check GFCI for tripping, which will prevent normal pump operation. Reset if necessary. USE ONLY HAYWARD GENUINE REPLACEMENT PARTS Page 6 of 16 Max-Flo™ PUMP Series...
  • Page 7: Start-Up And Operation

    Keep motor clean. Insure air vents are free from obstruction to avoid damage. Do NOT use water to hose off motor.  Occasionally, shaft seals must be replaced, due to wear or damage. Replace with genuine Hayward seal assembly kit. See “Shaft Seal Change Instructions” in this manual.
  • Page 8: Storing Pump For Winterization

    To reduce risk of injury, do not permit children to use this product. B. Disconnect all electrical power service to pump before beginning shaft seal replacement. C. Only qualified personnel should attempt rotary seal replacement. Contact your local authorized Hayward Dealer or service center if you have any questions.
  • Page 9 15. Fasten assembly to pump/strainer housing using the four (4) 3/8”" x 2" housing cap screws. (Be sure housing gasket is in place, and replace if damaged). Tighten alternately and evenly. USE ONLY HAYWARD GENUINE REPLACEMENT PARTS Page 9 of 16 Max-Flo™...
  • Page 10: Parts Listing

    MOUNTING FOOT CAP SCREW SPX1600Z5 SPX1600Z5 SPX1600Z5 SPX1600Z5 SPX1600Z5 SLINGER SPX0125F SPX0125F SPX0125F SPX0125F SPX0125F MOTOR-60 CYCLE SINGLE PHASE SPX1605Z1M SPX1607Z1M SPX1610Z1M SPX1615Z1M SPX1610Z2M USE ONLY HAYWARD GENUINE REPLACEMENT PARTS Page 10 of 16 Max-Flo™ PUMP Series IS2800X5 Rev. C...
  • Page 11: Troubleshooting

    1. Low voltage at motor or power drop (frequently caused by undersized wiring or extension cord use). Solution: Contact qualified professional to check that the wiring gauge is heavy enough. Your Hayward pump motor is equipped with an “automatic thermal overload protector.” The motor will NOTE automatically shut off if power supply drops before heat damage can build up causing windings to burn out.
  • Page 12 Solution: All seal leaks should be replaced at once. © Hayward Pool Products, 2011 All rights reserved. USE ONLY HAYWARD GENUINE REPLACEMENT PARTS Page 12 of 16 Max-Flo™ PUMP Series IS2800X5 Rev. C...
  • Page 13 The express limited warranty above constitutes the entire warranty of Hayward Pool Products with respect to its’ pool products and is in lieu of all other warranties expressed or implied, including warranties of merchantability or fitness for a particular purpose. In no event shall Hayward Pool products be responsible for any consequential, special or incidental damages of any nature.
  • Page 14 THIS PAGE INTENTIONALLY LEFT BLANK USE ONLY HAYWARD GENUINE REPLACEMENT PARTS Page 14 of 16 Max-Flo™ PUMP Series IS2800X5 Rev. C...
  • Page 15 THIS PAGE INTENTIONALLY LEFT BLANK USE ONLY HAYWARD GENUINE REPLACEMENT PARTS Page 15 of 16 Max-Flo™ PUMP Series IS2800X5 Rev. C...
  • Page 16: Warranty Card Registration

    New Installation Replacement  Please include me on all e-mail communications regarding Hayward Equipment or promotions. Mail to: Hayward Pool Products, 620 Division Street, Elizabeth, NJ 07207 Installation for: Attn: Warranty Dept In Ground Above Ground Or REGISTER YOUR WARRANTY ON-LINE AT WWW.HAYWARDNET.COM...

This manual is also suitable for:

Sp2807x10Sp2810x15Sp2815x20Sp2810x152

Table of Contents

Save PDF