Change Password - Kyocera FS-1370DN Operation Manual

Fs-1370dn operation guide (advanced)
Hide thumbs Also See for FS-1370DN:
Table of Contents

Advertisement

>Change ID
001
>Change ID
_
OK?
002
>Change Password
▌▌▌▌▌▌▌▌▌▌▌▌▌▌▌▌
>Change Password
_
OK?
010
2-66
Each time you press
appear in succession.
Change ID

Change Password

Note If a change is required, refer to the procedures in
Change ID (Administrator ID change) and Change
Password (Administrator Password change) below.
4
Press [OK] again. The administrator ID and password are
confirmed.
5
Press [MENU]. The display returns to Ready.
Change ID (Administrator ID change)
You can use this to change the administrator ID.
1
In step 3 in Password (Administrator Password input) above, press
or
while the Admin (Change) screen is displayed until
>Change ID appears. (E.g.: Where the administrator ID is 001)
2
When you press [OK], a blinking cursor (_) appears.
3
Press
or
to increase or decrease, respectively, the value at the
blinking cursor. Enter the ID to be changed. Use
the cursor right and left. Enter an ID consisting of between 1 and 21
numbers.
4
Press [OK]. A confirmation screen appears. (E.g.: Where the
administrator ID is changed to 002)
5
Press [OK]. The new administrator ID is confirmed.
6
Press [MENU]. The display returns to Ready.
Change Password (Administrator Password change)
You can use this to change the administrator password.
1
In step 3 in Password (Administrator Password input) above, press
or
while the Admin (Change) screen is displayed until
>Change Password appears.
IMPORTANT The administrator password is not displayed.
2
Press [OK]. A blinking cursor (_) appears.
3
Press
or
to increase or decrease, respectively, the value at the
blinking cursor. Enter the password to be changed. Use
move the cursor right and left. Enter a password consisting of
between 0 and 21 numbers.
4
Press [OK]. A confirmation screen appears. (E.g.: Where the
administrator password is changed to 010)
5
Press [OK]. The new administrator password is confirmed.
6
Press [MENU]. The display returns to Ready.
or
, the following settings to be changed
Using the Operation Panel
and
to move
and
to

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents