Kyocera FS-1370DN Operation Manual page 54

>>KIR Mode
? On
>>EcoPrint Mode
? Off
>>Resolution
? Fast 1200 mode
2-36
3
Press [OK]. A blinking question mark (?) appears.
4
Select On or Off using
5
Press [OK].
6
Press [MENU]. The display returns to Ready.
EcoPrint Mode (Selecting the EcoPrint mode)
By enabling EcoPrint mode, you can minimize the amount of toner used
during printing. Because images printed in this mode may be slightly
coarser than those printed in standard resolution, you should use
EcoPrint for test prints or other situations where high-quality prints are
not required.
EcoPrint setting is
Off (default)
Use the procedure below to select EcoPrint mode. The default setting is
Off.
1
Press while >Print Quality > is displayed.
2
Press or repeatedly until >>EcoPrint Mode appears.
3
Press [OK]. A blinking question mark (?) appears.
4
Select On or Off using
5
Press [OK].
6
Press [MENU]. The display returns to Ready.
Resolution (Selecting the print resolution)
You can set the default print resolution in four ways: 300dpi, 600dpi, Fast
1200 mode and Fine 1200 mode. The clarity of printed characters and
graphics becomes sharper in this order.
1
Press while >Print Quality > is displayed.
2
Press or repeatedly until >>Resolution appears.
3
Press [OK]. A blinking question mark (?) appears.
4
Select Fine 1200 mode, Fast 1200 mode, 600 dpi or 300
dpi using the or
5
Press [OK].
6
Press [MENU]. The display returns to Ready.
or .
EcoPrint setting is
On
or .
.
Using the Operation Panel