Usb Memory (Usb Flash Memory Selection) - Kyocera FS-1370DN Operation Manual

USB Memory
/
/00:Folder 1
/00:Folder 1
/01:Folder 2
/.../01:Folder 2
02:File 3
/.../01:Folder 2
? 02:File 3
Copies
2-16

USB Memory (USB flash memory selection)

This specifies the settings for removing the USB flash memory and
printing USB flash memory content. The USB Memory menu
automatically appears when you install the USB memory.
IMPORTANT This message is displayed only when the USB host
block is set to Unblock . For more information, refer to Interface
Block (Interface (external device) block setting) on page 2-58.
The options available in USB flash memory are as follows:
• Print File (Printing a file)
• Copies (Number of copies)
• Paper Source (Selecting the paper feed source)
• Remove Device (Removing the USB flash memory)
• Print File List (Printing a list of the files on a USB flash memory)
1
Press [MENU].
2
Press or
>
Note that menus shown in the list may vary depending on which
optional units installed in the printer.
Print File (Printing a file)
You can use this to specify printing for files in the USB flash memory.
1
Press while USB Memory > is displayed.
2
>Print File appears. In other displays, press
until the map appears.
3
Press [OK]. A question mark (?) appears.
4
Press [OK] again. The folder or file appears.
(For example : Folder 1)
Each time you press
succession.
To view lower-level folders or files, press
(For example : Folder 2)
To view folders or files on still lower levels, press
(For example : File 3)
IMPORTANT The Print File menu option is only displayed
when there is a PDF, TIFF or XPS file in the USB flash memory.
Note also that up to 3 levels of folders or files are displayed. It
might take some time before the folder or file name appears,
depending on the size of the USB flash memory or the number of
files.
You can move between the folder levels by pressing
and .
5
Press [OK]. A question mark (?) appears.
(For example : File 3)
6
Press [OK] again. Copies appears.
001
repeatedly until USB Memory > appears.
or , the next folder or file appears in
or repeatedly
.
.
and or
Using the Operation Panel