Netware (Netware Setting) - Kyocera FS-1370DN Operation Manual

>NetWare
>NetWare
? On
>>Frame Type
? Auto
2-60

NetWare (NetWare setting)

NetWare is a PC-based network operating system specifically for
servers.
NetWare is a client-server system that operates by installing the
NetWare OS on the server and dedicated client modules (NetWare
clients) on the client machines (running MS-DOS, OS/2, Windows, etc.).
The basic network layer protocol used is NetWare's own IPX
(Internetwork Packet eXchange)/SPX (Sequenced Packet eXchange),
but the system also supports TCP/IP.
The feature of the NetWare OS is that it is specifically for servers, unlike
general-purpose operating systems such as Windows NT and UNIX.
Only the minimum required for server operation can be performed from
the NetWare OS console on the server. Server and file management is
basically carried out using management tools from the clients. Also, all
drivers and protocol stacks are in the form of modules called NetWare
Loadable Modules (NLMs), and the ability of NLMs to load and unload
flexibly and dynamically is a major advantage of this system.
The default setting is On.
Note Check with your network administrator when selecting
network settings.
1
After entering the administrator ID and password, press
>
repeatedly until >NetWare > appears.
2
Press [OK]. A blinking question mark (?) appears.
>
3
Select On or Off using
4
Press [OK].
5
Press [MENU]. The display returns to Ready.
Frame Type (Frame type setting)
Sets the NetWare frame type. Frame is a term referring to a set of data
that flows through the network. The default setting is Auto.
1
Press while >NetWare On > is displayed. >>Frame Type
appears.
2
Press [OK]. A blinking question mark (?) appears.
3
Press or
[OK]. The message display toggles through the following types:
• Auto
• 802.3
• Ethernet-II
• 802.2
• SNAP
4
Press [OK].
5
Press [MENU]. The display returns to Ready.
or .
until the desired frame type appears and then press
or
Using the Operation Panel