Operating Instructions; Turning Power On And Off; Indicating Lamp - Hitachi CMP4202U User Manual

OPERATING INSTRUCTIONS

Main power switch
POWER OFF
button
POWER ON
button
AUTO PinP
RGB 1 RGB 2
MENU
ENTER
ID

Indicating lamp

SUB-POWER button
POWER ON/OFF
button
VOL
MUTE VOL
SIZE RECALL
VIDEO 1 VIDEO 2
RETURN
ID SET

Turning Power On and Off

To turn the monitor power ON, press the main power
switch on the monitor main unit to ON, and then press
the SUB POWER button or the ON/OFF or ON button on
the remote control.
To turn the monitor power OFF, press the SUB POWER
button or the ON/OFF or OFF button on the remote
control, and then press the main power switch on the
monitor main unit to OFF.
During normal use, the main power switch is set in the ON
position, and the monitor can then be turned ON/OFF using the
SUB POWER button or the ON/OFF button on the remote control.
Indicating lamp
Indicating
Power status
lamp
Off Off
Off
Lights red
(standby)
Lights green On
Off
Lights orange
(standby)
When the indicating lamp lights in orange or the message "NO
SYNC SIGNAL", "POWER SAVE" or "OUT OF FREQUENCY" appears
on the screen, there is something unusual about the status of
reception. See "POWER SAVE MODE" or "Symptoms That
Seemingly Appear to be Failures."
TIPS
• Avoid repeatedly turning the monitor on and off at short time
intervals. Failures might result from such operation.
• Turn off the main power switch before leaving the monitor out of
use for an extended period of time.
• If a power failure occurs while the main unit is running, it would
be powered on upon recovery from the failure. Turn off the unit
main power switch before leaving the main unit.
Operating
When the main power switch is set
to OFF.
When the main power switch is
ON, and the OFF button on the
remote control or the SUB POWER
button on the underside of the
front of the frame is OFF.
When the main power switch is
ON, and the ON button on the
remote control or the SUB POWER
button on the underside of the
front of the frame is ON.
When the main power switch is
ON, and the ON button on the
remote control or the SUB POWER
button on the underside of the
front of the frame is ON.
However, the state in POWER
SAVE mode