Table of Contents
Advertisement
OPERATING INSTRUCTIONS
• The main power switch is located at the back, on the
right side.
26
Indicating Lamp
Remote-control receiver
Main power switch
Power button
POWER button
Turning Power On and Off
• To turn the PDP TV power ON, press the main
power switch on the PDP TV main unit to ON, and
then press the POWER button of control panel or
the POWER button on the remote control.
• To turn the TV power OFF, press the POWER
button of control panel or the POWER button on
the remote control, and then press the main power
switch on the PDP TV main unit to OFF.
• During normal use, the main power switch is set in the
ON position, and the monitor can then be turned
ON/OFF using the POWER button or the POWER
button on the remote control.
Indicating lamp
Indicating Lamp
Power Status
Off
Off
Off
Lights Red
(Stand-by)
Off
Lights Orange
(Power Save)
Lights Green
On
When the indicating lamp lights in orange or the
message "CABLE NO INSERT"or "Blue picture"
appears on the screen, there is something unusual
about the status of reception. See "Power Save Mode"
or "Symptoms That Seemingly Appear to be Failures."
45 ~ 47
ATTENTION
• Avoid repeatedly turning the PDP TV on and off at
short time intervals. Failures might result from such
operation.
• Turn off the main power switch before leaving the
PDP TV out of use for an extended period of time.
• If a power failure occurs while the main unit is
running, it would be powered on upon recovery from
the failure. Turn off the unit main power switch
before leaving the main unit.
Operating
When the main power
switch is set to OFF.
When the main power
switch is ON, and the
POWER button is OFF.
When the main power
switch is ON, and the
power button is ON.
When the main power
switch is ON, and the
power button is ON.
Advertisement
Table of Contents
