Operating Instructions; Turning Power On And Off; Indicating Lamp - Hitachi 28LD5000TA User Manual

OPERATING INSTRUCTIONS

Main power switch
(28")
POWER ON/OFF
D / N
button
i +
MENU
-
OK
D VD
1 2
4 5
7 8
0
AV1 AV2
14

Indicating lamp

SUB-POWER button
I / II
A / B 2- 4- 12
P+
+
P-
FREEZE
ZOOM
3
6
9
AV3 AV4
RGB1 RGB2

Turning Power On and Off

To turn the monitor power ON, press the main power
•
switch on the monitor main unit to ON, and then press
the SUB POWER button or the ON/OFF or ON button on
the remote control.
To turn the monitor power OFF, press the SUB POWER
•
button or the ON/OFF or OFF button on the remote
control, and then press the main power switch on the
monitor main unit to OFF.
• During normal use, the main power switch is set in the ON
position, and the monitor can then be turned ON/OFF using the
SUB POWER button or the ON/OFF button on the remote control.
Indicating lamp
Indicating
Power status
lamp
When the main power switch is set
Off Off
to OFF.
When the main power switch is
ON, and the OFF button on the
Off
Lights red remote control or the SUB POWER
(standby)
button on the top of the front of the
frame is OFF.
When the main power switch is
ON, and the ON button on the
Lights green On remote control or the SUB POWER
button on the top of the front of the
frame is ON.
When the main power switch is
ON, and the ON button on the
remote control or the SUB POWER
Off
Lights orange button on the top of the front of the
(Power Save)
frame is ON.
However, the state in POWER
SAVE mode
When the indicating lamp lights in orange or the message "No Sync.
Signal", "Power Save" or "Invalid Scan Freq." appears on the
screen, there is something unusual about the status of reception.
See "Power Save Mode" or "Symptoms That Seemingly Appear to be
Failures."
23 25
ATTENTION
• Avoid repeatedly turning the monitor on and off at short time
intervals. Failures might result from such operation.
• Turn off the main power switch before leaving the monitor out of
use for an extended period of time.
• If a power failure occurs while the main unit is running, it would
be powered on upon recovery from the failure. Turn off the unit
main power switch before leaving the main unit.
Operating